Turntable overkill

Published on 02/04/2021 @16:48:00 by vigilante sculpting

I took an evening and built myself a little display turn table, using a stepper motor ripped from an old printer, hooked up to an Arduino running grbl (software for controlling a CNC machine) and a motor control circuit that I built ages ago.

The electronics is overkill, but it works great and I will at some point shrink it down to just a simple motor controller and an on/off button or something :)

No comments

Add a comment

To make a comment, please send an e-mail using the form below. Comments are hand-moderated and may take a while to appear, please be patient!
For general rules and site policies regarding comments, and how this works, please see this post
Your e-mail address will never be shared.